So I've spent upwards of £600 on "non-linear guide" linear guides if you get my meaning. At the last count on my CoreXYUVAB I have 60 odd sets of twin bearing Delrin wheels at around £10 a pop. Not because I believe it will give my any better prints but because it would likely save me some money. "Why don't you use linear guides" and my answer is always the same - "the Open Builds V slot members are linear guides - so why would I want to attach a linear guide to a linear guide?"īut like if was starting again, I might consider using "conventional" linear guides. I get asked the question quite a lot on my blog and YouTube channel -i.e. Ouch - that's harsh! Especially the bit about "noticeably better prints". V-Slot/Roller goes with sub $50USD 8 bit boards. Considered as a percentage of the total cost of the printer, they are a trivial cost for noticeably better prints.Įspecially because you are asking on the forums for one of the most "high end" controllers available. Said in Need your advice, V-Slot VS Linear Rail.:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |